Xerox DocuMate 765 User Manual page 86

DocuMate 765 Scanner User's Guide
7. You can now either click on one of the black boundary squares and
drag your mouse to resize the boundary box. Click in the middle of
the boundary box then drag your mouse to move the boundary box
around the preview area.
You can also manually enter the coordinates where the sub area
should be located on the page in the Area section.
First, select the units of measurement you want to use. The available
options are Pixels, Inches and Centimeters. The instructions here are
using inches as an example.
• X—input the starting point of the image from the left side of the
page. For example, the left most edge of the logo is 6 inches from
the left side of the paper, input 6 in the X coordinate field.
• Y—input the starting point of the image from the top of the page.
For example, the top of the logo is 2 inches from the top of the
page, input 2 in the Y coordinate field.
• Width—type in the width of the image, the minimum width is 2
inches.
• Length—type in the length of the image, the minimum length is 3
inches.
8. Click on OK to save the changes and close the window.
You can also leave the window open and add a 2nd or 3rd sub area to
the front side, or add a sub area for the back side of the paper.
9. Place your page back in the scanner. Click on the Preview button in
the Page Layout tab. The scanner will scan the image and the scan
results in the preview area should match the settings you chose in the
Sub Area window.
Scanning from ISIS
79