Fax Send Setup - Xerox Phaser 8860 System Administrator Manual

Starting Rate: This setting specifies the initial fax transmission and reception rate. The
default settings are 33.6 kbps (Super G3) for the Phaser 8860MFP printer. The following
values are supported:
■ 4800 bps
9600 bps
■
■ 14.4 kbps (G3)
■ 19.2 kbps
■ 28.8 kbps
■ 33.6 kbps (Super G3)
Error Correction Mode: This setting turns Off or On automatic error correction during fax
transmission and reception. The default setting is On.

Fax Send Setup

Transmission Report: This setting specifies when a fax Transmission Report is printed.
Transmission Reports provide feedback about the fax transmission, such as when it was sent,
call duration, etc. The default setting is Error Only.
■ Always: A Transmission Report is printed for each fax sent.
Never: A Transmission Report is not printed for any fax sent.
■
■ Error Only: A Transmission Report is only printed when a fax error occurs for one or
more recipients.
Note:
You can override this setting at the control panel.
Report with reduced 1st page: This setting turns On or Off printing a reduced image of the
first faxed page on the Transmission Report. The default setting is On.
Redial Count: This setting determines the number of redial attempts the system makes after
encountering a busy signal. The default setting is 3 Times.
Redial Time Interval: This setting specifies how many minutes the system waits to redial
after encountering a busy signal. The default setting is 3 Minutes.
Auto Resend Policy: This setting specifies what the system does with fax pages after an
interruption. The default setting is Unsent pages.
■ Unsent pages: Send pages that were not sent.
■ All pages: Resend all pages.
Auto Resend Count: This setting specifies the number of times to restart a fax transmission
after an interruption. The default setting is 3 Times.
Resolution: This setting determines the fax print resolution. The default setting is
Fine (200 x 200). The following values are supported:
■ Standard (200 x 100)
■ Fine (200 x 200)
Super Fine (200 x 400)
■
System Administrator Guide
6-3
Fax Defaults