Installation Instructions; Technical Specifications; Environmental Conditions; Regulatory Compliance - Altronix Pace2KRT Installation Manual

Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all
local codes and authorities having jurisdiction. Wiring should be UL Listed and/or Recognized wire
suitable for the application.
Pace1KR and Pace2KT are not intended to be connected to outside plant leads and should be installed
indoors within the protected premises. Pace1KR and Pace2KT are intended for indoor use only.
1. Pace1KR installation:
a. Secure unit to the desired mounting surface with a proper fastening device utilizing the unit's
mounting hole (Fig. 2a, 3a, pg. 3). Unit should be mounted in proximity to ethernet switch/
network, NVR or video server.
b. Connect structured cable from ethernet midspan or endspan device to RJ45 jack marked
[PoE Input] (Fig. 2, 3, pg. 3).
c. UTP / 2-wire: Connect UTP to connector marked [+, –] (Fig. 2, 3, pg. 3).
2. Pace2KT installation:
a. Secure unit to the desired mounting surface with a proper fastening device utilizing the case's
mounting hole. Unit should be mounted in the proximity of camera/device.
b. Connect structured cable from IP camera/device to RJ45 jack marked [PoE Out] (Fig. 2, 3, pg. 3).
c. If using multiple Pace2KRT kits, connect structured cable to the next Pace1KR's RJ45 jack
marked [PoE Input] (Fig. 3, pg. 3). Either [PoE Out] port can be used.
d. Connect UTP to the connector marked [+, –] from receiver (Pace1KR) (Fig. 2, 3, pg. 3).
Parameter
Connections
Input Power
Pace1KR
PoE Output Power
Pace2KT
Indicators
Environmental
Conditions
Regulatory
Compliance
Weights (approx.)
- 2 -

Installation Instructions:

Technical Specifications:

Description
RJ45 for CAT5/6 or higher ethernet link.
UTP (2-wire) screw terminals to interconnect receiver/transceiver
Midspan or endspan port connected to first Pace1KR.
PoE compliant to IEEE 802.3af (15W) and PoE+ compliant to IEEE 802.3at (30W)
PoE outputs (2) .3at (25W each). Total not to exceed 25W.
Yellow (RJ45 connector):
Green (RJ45 connector):
Green Link LEDs:
Operating Ambient Temperature: UL60950-1
Pace1KR:
Pace2KT: For 15W:
For 25W:
Storage Temperature:
Relative Humidity:
Operating Altitude:
CE European Conformity.
Product: 0.4 lb. (0.18 kg) | Shipping: 1 lb. (0.45 kg).
On - Link, Off - No Link, Blinking - Activity.
On - 100Base-TX, Off - 10Base-T.
Link active
– 20ºC to 49ºC (– 4ºF to 120.2ºF).
– 40ºC to 75ºC (– 40ºF to 167ºF).
– 40ºC to 49ºC (– 40ºF to 120ºF).
– 40ºC to 75ºC (– 40ºF to 167ºF).
20 to 85%, non-condensing.
– 304.8 to 2,000m.
Pace2KRT Installation Guide