Checking The Hydrostatic Braking Distance; Overview Of Reverse Speeds; Overview Of Displayed Traction Speeds - Toro 03952 Operator's Manual

Checking the Hydrostatic Braking Distance

Note:
This machine will dynamically brake and stop when you return the traction pedal to
neutral.
Note:
For smooth deceleration, use your foot to slowly control the traction pedal back to
neutral. Do not take your foot off the pedal and allow it to snap back to the neutral position
unless you intend to stop quickly.
1. Bring the machine to a complete stop approximately 3.7 m (12 ft) from the maximum
transport speed of 10 mph.
2. On flat, dry pavement, mark out the start and end of 3.7 m (12 ft).
3. Drive the machine at the maximum transport speed of 16 km/h (10 mph) and remove
your foot at the start of the 3.7 m (12 ft).
4. Check if the machine stops within 0.6 m (2 ft) of the end mark (3.7 m or 12 ft).
5. Contact your Toro distributor if the stopping distance of the machine is not within 0.6 m
(2 ft) of this distance.

Overview of Reverse Speeds

Transport Reverse Speed
• If the maximum transport speed set by the supervisor is above 8.0 km/h (5.0 mph), the
maximum reverse speed is 8.0 km/h (5.0 mph).
• If the maximum transport speed set by the supervisor is at or below 8.0 km/h (5.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.
Mowing Reverse Speed
• If the maximum mow speed set by the supervisor is above 6.4 km/h (4.0 mph), the
maximum reverse speed is 6.4 km/h (4.0 mph).
• If the maximum mow speed set by the supervisor is at or below 6.4 km/h (4.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.

Overview of Displayed Traction Speeds

This machine displays estimated traction speeds in kilometers per hour (km/h) or miles per
hour (mph).
• The instantaneous speed is displayed in the upper left-hand corner of the cruise control
and virtual pedal stop screens.
• The traction speeds are estimated, and calibrated to be most accurate at 8.0 km/h (5.0
mph) while mowing. Displayed speeds are accurate when it is 0.8 km/h (0.5 mph) above
or below the display speed while driving on dry, flat pavement.
• Contact your authorized Toro distributor if the machine's observed speeds deviate more
than 2.4 km/h (1.5 mph) from the displayed speeds.
Operation: Before Operation Page 5–14 3464-482 A