Checking The Hydrostatic Braking Distance - Toro Reelmaster 5010-H Operator's Manual

Overview of the InfoCenter Display (continued)
2. Use the left and right navigation buttons to increase and decrease the maximum mow
speed in 0.8 km/h (0.5 mph) increments between 1.6 and 12.9 km/h (1.0 and 8.0 mph).
Setting the Maximum Allowed Transport Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note:
This setting is retained in memory and applied to the traction speed until you change
it.
1. In Machine Settings, scroll down to Transport Speed.
2. Use the left and right navigation buttons to increase and decrease the maximum
transport speed in 0.8 km/h (0.5 mph) increments between 8.0 and 16.0 km/h (5.0 and
10.0 mph).
Turning the Smart Power ON/OFF
1. In Settings, scroll down to Smart Power.
2. Press the right navigation button to switch between O
Setting the Acceleration Mode
1. In Machine Settings, scroll down to Acceleration.
2. Press the right navigation button to switch between L
Setting the Front and Rear Backlap Speeds
1. In Machine Settings, scroll down to Front Backlap or Rear Backlap.
2. Use the right and left navigation buttons to increase and decrease the backlap speeds.

Checking the Hydrostatic Braking Distance

Note:
This machine will dynamically brake and stop when you return the traction pedal to
neutral.
Note:
For smooth deceleration, use your foot to slowly control the traction pedal back to
neutral. Do not take your foot off the pedal and allow it to snap back to the neutral position
unless you intend to stop quickly.
1. Bring the machine to a complete stop approximately 3.7 m (12 ft) from the maximum
transport speed of 10 mph.
2. On flat, dry pavement, mark out the start and end of 3.7 m (12 ft).
3. Drive the machine at the maximum transport speed of 16 km/h (10 mph) and remove
your foot at the start of the 3.7 m (12 ft).
4. Check if the machine stops within 0.6 m (2 ft) of the end mark (3.7 m or 12 ft).
3464-478A
N
OW
Page 5–14
and O .
FF
, M , and H .
EDIUM IGH
Operation: Before Operation