Table of Contents
Advertisement
Positioning the Turf Compensating Spring and Installing
the Hose Guide (continued)
3. Remove the flange locknut (3/8 inch)
securing the bolt
carrier frame, and remove the compensation
spring from the cutting unit.
Note:
from the bolt.
4. Assemble the bolt
spring to the right tab
with the flange locknut (3/8 inch)
5. Align the studs
the holes in the cutting-unit frame and the turf-
compensator bracket
Note:
aligns toward the center of the machine
6. Assemble the hose guide and turf-
compensator bracket to the cutting-unit frame
with the 2 flange locknuts (3/8 inch)
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
Setup: Installing the Cutting Units
to the right tab
Do not remove the flange serrated nut
of the turf compensation
of the carrier frame
of the left hose guide with
.
The support loop of the hose guide
of the
G410295
.
G410296
.
.
G410297
Page 3–4
3464-482 A
Advertisement
Table of Contents
