Define The Output As A Pulse, Frequency Or; Setup" Menu → Pulse/Frequency/Switch Output; Pulse/Frequency/Switch Output; To N - Endress+Hauser Proline Prosonic Flow P 500 Operating Instructions Manual

Proline Prosonic Flow P 500 HART
Parameter

Operating mode

Terminal number

Signal mode
Endress+Hauser
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣

Pulse/frequency/switch output

1 to n

Operating mode
Terminal number
Signal mode
Switch output function
Assign diagnostic behavior
Assign limit
Assign flow direction check
Assign status
Switch-on value
Switch-off value
Switch-on delay
Switch-off delay
Failure mode
Invert output signal
Parameter overview with brief description
Prerequisite
–
–
–
Description
Define the output as a pulse,
frequency or switch output.
Shows the terminal numbers
used by the PFS output
module.
Select the signal mode for the
PFS output.
Commissioning
→  115
→  115
→  115
→  116
→  116
→  116
→  116
→  116
→  116
→  117
→  117
→  117
→  117
→  117
Selection / User Factory setting
interface / User
entry
• Pulse Pulse
• Frequency
• Switch
• Not used –
• 24-25 (I/O 2)
• 22-23 (I/O 3)
• Passive Passive
*
• Active
• Passive NE
115