Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 6280 User Manual

Dynamic Methods of Setting the Printer's IP Address

There are two protocols available for dynamically setting the printer's IP address:
• DHCP (enabled by default on all Phaser printers)
• AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn
on/off DHCP.
Note: You can view the printer's IP address at any time. On the control panel, select Menu .
Then select Information Pgs and press the OK button. Finally, select Configuration , and
then press the OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the control panel, select the Menu button.
2. Select the Admin menu, and then press the
3. Select the Network Setup menu, and then press the
4. Select the TCP/IP menu, and then press the
5. Select IPv4 , and then press the
6. Select Get IP Address , and then press the OK button.
7. Select DHCP , and then press the OK button.
Using CentreWare IS
To turn on/off the DHCP protocol:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Select Properties .
4. Select the Protocols folder on the left navigation panel.
5. Select TCP/IP .
6. In the Get IP Address field, select the DHCP/Autonet option.
7. Click the Save Changes button.
Configuring the Network Address
button.
OK
OK
button.
OK
button.
OK
Phaser® 6280 Printer
36
button.