Dynamic Methods of Setting the Printer's IP Address
Set the printer's IP address using any of the following methods. DHCP is enabled by default on
all Phaser printers.
■
DHCP
■
CentreWare IS
■
AutoIP
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Enabling DHCP on the Printer
Verify that the printer DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default on all Phaser printers.
Note:
To determine the printer's IP address, select
panel.
See also:
Control Panel Features
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the printer
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
Printer Identification
on page 1-6
Phaser® 8500/8550 Color Printer
2-6
Configuring the Network Address
on the control