Cleaning The Printer; Cleaning The Exterior; Cleaning The Interior - Xerox Phaser 6280 User Manual

Cleaning the Printer

This section describes how to clean the printer in order to maintain it in good condition and
print clean printouts all the time.
Warning: Be sure to turn off and unplug the printer before accessing the interior of the
printer for cleaning, maintenance, or fault clearance. Access to a live printer's interior can
cause electric shock.

Cleaning the Exterior

Clean the exterior of the printer about once a month. Wipe the parts with a wet but well-
wrung soft cloth. Then wipe with another dry soft cloth. For stubborn stains, apply a small
amount of neutral detergent, and gently wipe the stain off.
Note: Do not spray the detergent directly on the printer. The liquid detergent may enter
the printer through a gap and cause problems. Never use cleaning agents other than water
or neutral detergent.

Cleaning the Interior

After clearing paper jams or replacing the print cartridge, inspect the inside of the printer
before closing the printer covers.
Warning: Never touch a labeled area found on or near the heat roller in the fuser. You can
get burned. If a sheet of paper is wrapped around the heat roller, do not try to remove it by
yourself to avoid injuries or burns. Switch off the printer immediately. Refer to the Xerox
Support website, www.xerox.com/office/6280support.
• Remove any remaining pieces of paper.
• Remove any dust or stains with a dry clean cloth.
Phaser® 6280 Printer
142

Cleaning the Printer