Overview Of Network Setup And Configuration - Xerox Phaser 6280 User Manual

Overview of Network Setup and Configuration

To set up and configure over the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the Configuration page and keep it for referencing network settings.
4. Set the printer's IP address. To do this, see
Address on page 36.
5. Install the driver software on the computer from the Software and Documentation
CD-ROM. For information on driver installation, see the section in this chapter for the
specific operating system you are using.
6. Print a Configuration page to verify the new settings.
Note: If the Software and Documentation CD-ROM is not available, you can download the
latest driver from www.xerox.com/drivers.
Overview of Network Setup and Configuration
Dynamic Methods of Setting the Printer's IP
Phaser® 6280 Printer
32