Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 7400DN User Manual

Dynamic Methods of Setting the Printer's IP Address

Set the printer's IP address using any of the following methods. DHCP is enabled by default on
all Phaser printers.
■
■
■
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Enabling DHCP on the Printer
Verify that the printer DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default on all Phaser printers.
Note:
panel.
See also:
Changing or Modifying the IP Address Using CentreWare IS
CentreWare IS provides a simple interface that enables you to manage, configure, and monitor
networked printers from your desktop using an embedded web server. For complete
information about CentreWare IS, click the Help button in CentreWare IS to go to the
CentreWare IS Online Help.
After setting the printer's IP address, you can modify TCP/IP settings using CentreWare IS.
1.
2.
3.
4.
5.
6.
Downloaded From ManualsPrinter.com Manuals
DHCP
CentreWare IS
AutoIP
To determine the printer's IP address, select
Control Panel Features on page 1-8
Launch your web browser.
Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
Click Properties.
Select the Protocols folder on the left sidebar.
Select TCP/IP.
Enter or modify the settings, and then click Save Changes at the bottom of the page.
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the printer
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
Printer Identification
Phaser® 7400 Color Printer
2-6
Configuring the Network Address
on the control