Automatically Setting The Printer's Ip Address; Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 8560 User Manual

Xerox phaser 8560: user guide
Hide thumbs Also See for Phaser 8560:
Table of Contents

Advertisement

Automatically Setting the Printer's IP Address

If the printer is connected to a small established TCP/IP network without a DHCP server, use
the installer on the Software and Documentation CD-ROM to detect or assign an IP address to
your printer. For further instructions, insert the Software and Documentation CD-ROM into
your computer's CD-ROM drive. After the Installer launches, follow the prompts for
installation.
Note:
For the automatic Installer to function, the printer must be connected to an established
TCP/IP network.

Dynamic Methods of Setting the Printer's IP Address

There are two protocols available for dynamically setting the printer's IP address:
DHCP (enabled by default on all printers)
AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/off
DHCP.
Note:
You can view the printer's IP address at any time. On the control panel, select
, press the OK button, select
Information
OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1.
On the control panel, select
2.
Select
Connection Setup
3.
Select
Network Setup
4.
Select
TCP/IP Setup
5.
Select
DHCP/BOOTP
6.
Press the OK button to run the selection
Using CentreWare IS
To turn on/off the DHCP protocol:
1.
Launch your web browser.
2.
Enter the printer's IP address in the browser's Address field.
3.
Select Properties.
4.
Select the Protocols folder on the left navigation panel.
5.
Select TCP/IP.
6.
In the BOOTP/DHCP Settings section, set the BOOTP/DHCP option to On or Off.
7.
Click the Save Changes button at the bottom of the page.
Printer Identification
Printer Setup
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
or
AutoIP
.
On
or
Phaser® 8560/8860 Printer
2-6
Configuring the Network Address
, and then press the
Off
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Phaser 8860

Table of Contents