Replacing The Motor - JMA NOMAD GO User Manual

WASTE DISPOSAL
5) Move the motor (N) so the two wheels move closer toge-
ther.
6) Remove the old belt. Remove it by moving it around the
brush.
7) Fit the new belt and visually check it is in the right place.
8) TIGHTENING THE BELT: By turning the tensioning screw
(Z), the motor (N) will move towards the bottom of the
machine and the belt will consequently become more tense.
When you think the belt is tense enough, secure the motor
(N) using the two screws (F).
See Figure 24

6.13 REPLACING THE MOTOR

Follow the steps below to do this:
Switch off the power switch (11), switch off the
master switch (15), close the protective screen (16)
and check that the machine is NOT connected to
the battery charger.
1) Release the three screws securing the cutter and brush
protector and then remove it.
2) Release the tensioning screw (Z) using the 3 mm Allen key.
3) Access the interior of the machine as indicated in Section
6.10 of this manual.
4) Disconnect the two wires from the motor. Note down the
position of each one beforehand.
5) Remove the motor (N). Remove the two screws (F) using
the 5 mm Allen key to do so.
6) Insert the new motor (N) without tightening the two
screws (F) too much.
7) Connect the two wires to the motor.
8) Fit the belt and visually check it is in the right place.
9) Tighten the belt as indicated at the end of Section 6.12 of
this manual.
See Figure 25
33 33
EN