Xerox DocuPrint N4525 User Manual page 82

Symptom: Light or faint prints
The overall image is lighter than normal.
4525-56
Symptom: Blank prints
The entire printed page is blank with no visible print.
4525-57
68
Possible causes and solutions:
If you are using Draft Mode, turn off Draft Mode.
I
The toner level may be low. Remove the Laser
I
Print Cartridge and carefully shake it several
times, then re-install it. (This may help
redistribute the remaining toner before having
to replace the cartridge.) If the Laser Print
Cartridge is empty, replace it.
The paper stock may be damp. Replace the
I
paper stock.
Possible causes and solutions:
If you just installed a new Laser Print Cartridge,
I
the yellow sealing tape may still be in place.
Remove the tape.
Multiple sheets may have been fed from the
I
paper tray at the same time. Remove the paper
from the paper tray and fan it. Also, ensure that
the paper is correctly loaded in the tray.
Printable data may not have been received from
I
the computer. To test this, print a Configuration
Sheet, as described on the previous page. If the
Configuration Sheet is normal, check the
Interface cable between the computer and
printer, the printer set up, and application
software. If the Test Print is blank, contact your
Customer Support Center.
The Laser Print Cartridge may be defective or
I
low on toner. Replace the Laser Print Cartridge.
DocuPrint N4525 Network Laser Printer