Home screen
This is the Home screen and descriptions of it's menus. Use your finger or included stylus pen to operate the touch
screen.
① Timer
If one of two timer displays is pushed, you will
enter the Timer screen of a Linkage menu.
In the button mode of a timer set, it can also
be made a start/stop.
A push on reset will reset a time.
② Menu Button
• System menu • Linkage menu
③ System Selection
•FASSTest26CH •FASSTest18CH •FASSTest12CH
•FASST MULTI •FASST 7CH •S-FHSS •T-FHSS
④ System timer/Reset
• This shows the total accumulated time used for
the transmitter. This can be reset.
(Hour):(Minute):(Second)
Push this area to reset the timer.
⑤ Voltage of Rx/Ext battery
Information from the receiver is displayed
when using a bidirectional system.
FASSTest/T-FHSS Only.
⑥ Home2
A timer and Telemetry data change to Home2
screen by which it was indicated by expansion.
⑦ RF Indicator
"ON AIR" or "RF OFF"
⑧ Digital trim (T1 to T6)
Push this area to enter the Dial Monitor screen.
*Please note that the screens in this manual may differ slightly from the
actual transmitter.
⑤
①
②
③
④
31
your・aircraft.
and・try・to・charge・the・battery・regularly.・If・the・battery・
alarm・ sounds・ and・ its・ warning・ symbol・ is・ displayed,・
land・your・aircraft・immediately.
⑥
⑦
→
⑨ User's name
Push this area to enter the User's Name
Setting screen.
⑩ Condition
The condition name that is currently used is
displayed here.
• Push this area to enter the Condition
Select screen.
⑪ Battery Indicator
•When the remaining battery reaches 10%,
the alarm will beep. Land your aircraft
immediately.
⑫ Menu Button
• Model menu
⑬ Model Name
The model name that is currently used is
displayed here.
• Push this area to enter the Model Select
screen.
⑭ Clock
This shows the today's date and the current
time.
• Push this area for the Date & Time Setting
screen.
WARNING
Be・ sure・ to・ confirm・ the・ model・ name・ before・ flying・
Check・ the・ remaining・ battery・ as・ often・ as・ possible・
⑧
⑨
⑩
GO to TABLE OF CONTENTS
⑪
⑫
⑬
⑭