Table of Contents
Advertisement
AI Equalizer
The AI EQ MASTER is a self-learning graphic equalizer. The built-in self-learning algorithm can
automatically adjust the master tone frequency response curve based on a selected sound type and
style of music. This is helpful to quickly achieve an almost ideal baseline for tone adjustments.
To use the feature:
•
Add an Equalizer module at the desired position in the effect chain.
•
Select "AI EQ Master" in the EQ category.
•
Use the drop-down menus to select the Type of sound (Clean, Overdrive, Distortion) and the
Genre of music you want to use (Rock, Pop, Blues ...).
•
Click the red button to start the learning process and play a phrase until the progress bar
below the buttons reaches the end and a frequency response curve is generated.
Note: If no curve is generated after the progress bar has reached the end, the AI was unable
to extract enough information from your playing to generate the curve. Start the learning
progress again and play a greater variety of chords in different positions on the neck to
generate a larger sample size for the AI.
•
Use the 5-band equalization controls below to fine-tune the results to your preference.
•
Click on the areas below the EQ controls to cycle through Gain, Frequency and Q adjustments.
•
Compare the difference in tone before and after processing by clicking the ON/OFF button.
•
If you are not satisfied, you can click the trashcan icon to delete and start a new learning
process.
Note: The learning results are stored with the preset (don't forget to save before switching presets)
and can be used in this preset only. You have to go through the learning process for each preset you
want to use the AI EQ Master with.
CTRL Mode
The CTRL (control) mode is a footswitch mode based on the currently selected preset. It can be used
to control up to four modules in the effect chain of the current preset the same way you would
control stompboxes on a physical pedal board using the ON/OFF footswitches of individual pedals.
Alternatively, one of the footswitches can be configured for Tap Tempo input.
The ▼, A, B and C footswitches of the GE1000 can each be configured to act as an ON/OFF switch for
one of the effect modules within the current preset's effect chain or to act as a tap tempo input.
The configuration of the footswitches only affects the currently selected preset.
You can have different CTRL mode footswitch configurations for each preset.
21
Advertisement
Table of Contents
