Xerox DocuPrint 180 System Configuration Manual page 76

SETTING THE SYSTEM CONFIGURATION
4-18
•
Number of Sheets — Specifies the number of pages you
want to print from the sample file. The range is 0 to 500
sheets. The default is 10 sheets.
•
Number of Sets (DFA systems only) — Specifies the
number sets to create, each containing the number of
sheets specified.
•
Finishing Function Option (DFA systems only) —
Enables you to specify finishing functions 1 or 2 for a third-
party finishing device, if desired.
•
Mode — Specifies whether the sample is printed in simplex
or duplex mode. Simplex is the default. If you select duplex,
the same sample is printed on both sides of each sheet.
•
Printer Tray — Specifies the input tray grouping from which
paper will be fed. (Refer to the "Specifying the input
configuration" section later in this chapter.)
•
Bin Group — Specifies the output bin grouping to which the
printed samples are sent. (Refer to the "Specifying the
output configuration" section later in this chapter.)
Note: If Bin 1 (sample tray) is not selected, the printed
sheets are offset every six sheets.
3. Click Print Samples to initiate printing. Your samples are
delivered to the bin group selected on the Sample Printing
window.
XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM