Xerox DocuPrint 180 System Configuration Manual page 29

XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
INTRODUCTION TO THE GRAPHICAL USER INTERFACE
•
Finishing — Displays "Enabled" if the system is configured with
a bypass transport, and "Finishing" is selected from the Output
Configuration window. For information on specifying finishing
attributes, refer to the section "Creating a new output
configuration" in the chapter "Setting the system configuration.
If the system has no bypass transport, this field is grayed-out
and displays "Disabled."
•
Page Order Within Set — Displays the current setting for the
order in which pages are placed in the output bin, from 1 to N
(ascending) or N to 1 (descending). If your system does not
have a bypass transport, or if the Finishing field displays
"Disabled," this field is grayed out and always displays "N to 1."
•
End of Set — If a bypass transport is installed on your system,
this field displays the criterion (MARKFORM or Offset Stacker)
that was selected from the Job Attributes window to indicate the
end of a set or segment within a job.
If your system does not have the stitcher/stacker configuration
or a bypass transport, or if the Finishing field displays
"Disabled," this field displays grayed-out and always displays
"Offset."
1-17