Xerox DocuPrint 180 System Configuration Manual page 110

SETTING THE SYSTEM CONFIGURATION
4-52
2. Make any desired changes in the fields described below.
•
Bin Selection Mode — Specifies how the IPS will
determine the bin to which the job will be delivered.
The option buttons are:
— Use Default Bin — Output will be delivered to the bin
— Allow Host Control — The host handles bin
Note: If you are enabling DFA, select "Allow Host Control"
for the bin selection mode.
•
Default IPDS Bin — Specifies the number for the bin to
which output will be delivered if "Use Default Bin" is selected
from the Bin Selection Mode menu, or if a bin number is not
specified by a job on the host.
Note: Output is delivered to the default bin if one of the
following conditions applies:
— "Use Default Bin" is selected as the Bin Selection
— "Allow Host Control" is selected as the Bin Selection
— "Allow Host Control" is selected as the Bin Selection
Figure 4-40. Default IPDS Bin pull-down menu
Note: The IPDS Bin 1 row is set to Sample Tray, and
cannot be changed. If you want your output to be delivered
to the stacker trays, you must select something other than
Bin 1 for the Default Bin Number.
•
(DFA systems only) Check the "Offset on Jam" box to offset
the first sheet after a jam.
•
(DFA systems only) Check the "Finishing" box then click the
Finishing Attributes button to specify the finishing attributes.
Refer to "Specifying finishing attributes" later in this section.
XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
you designate from the Default Bin Number pull-down
menu.
selection, and the system uses the bin you selected to
correspond to the IPDS Bin number.
Mode.
Mode, but there is no OUTBIN statement for the host.
Mode, but the OUTBIN specified is greater than the
number of stackers.