Throttle Control For Kar-Tech - J&M Speed Tender Pro Manual

Problems
Excessive wear to belt edge - Rubber skirting is
worn or out of place
Boom arm will not move up or down - Engine RPM
slow
Boom arm will not move up or down - Hydraulic
pump is not producing sufficient pressure or
volume to hydraulic cylinder
Hydraulic unit squeals
Hydraulic unit has poor performance at high RPM
Remote Speed Control for Kar-Tech Remotes
The remote throttle option for the Kar-Tech Wireless System only works with the wireless J&M Mega Remote. This remote and receiver
combination provides the output required to drive the throttle control via the 2-wire Deutsch connection. Press the up navigation button
on the remote to increase the throttle. Press the down navigation button to decrease the throttle. Both buttons will only be activated
when the conveyor is running.
NOTE: Remote throttle control is not available when the user is setting up Auto Dispense weight and door selection in the remote.
26
Troubleshooting
Solutions
a. Replace rubber skirting.
b. Adjust rubber skirting.
a. Increase engine RPM.
a. Check for pinched or leaking hydraulic lines.
b. Allow hydraulic oil to warm up.
c. Increase engine RPM.
d. Hydraulic fluid level low.
e. Hydraulic filter clogged.
f. Check for proper oil viscosity.
g. Check if hydraulic pump is worn out.
h. Ensure battery is fully charged.
i. Check wiring to valve body and hydraulic pump.
a. Check sight glass on hydraulic unit reservoir and fill if necessary.
b. Run engine at reduced speed for 5-10 minutes to warm up oil.
c. Clean/replace filler cap/breather.
d. Clear obstruction in suction hose.
e. Replace plugged/dirty oil filter element.
a. Clean pressure relief in control valve or replace.
b. Check sight glass on hydraulic unit reservoir and fill if necessary.
c. Replace plugged/dirty oil filter element.
d. Charge battery.

Throttle Control for Kar-Tech