Table of Contents
Advertisement
Hydraulic Power Unit Operation
1.
Ensure all fittings and hardware are in proper operating condition. Replace if worn or broken. Check engine fluid levels and sight
gauge on reservoir for proper operating levels.
2.
Slide the fuel shut-off lever to the "ON" position.
3.
Slide choke to the "ON" position.
4.
Turn the key to the start position. Once engine starts, release key.
5.
After starting, allow the engine to warm up. Slide choke to the "OFF" position and increase throttle speed.
6.
The engine must throttle at, or above 80% throttle for 3 seconds to begin charge. After the 3 seconds at 80% throttle the battery will
continue to charge until the engine is turned off.
7.
To turn the engine off, slide the fuel shut-off lever to the "OFF" position.
8.
Turn key off.
NOTE: In extremely cold weather, it is best to allow engine and hydraulics to warm up before increasing throttle speed.
NOTE: If a hydraulic leak appears, turn off immediately and take appropriate action.
NOTE: See engine operator's manual for more details on upkeep and service.
WARNING: Purge hydraulic system of air before operating SpeedTender Pro to prevent serious injury or death.
WARNING: Wear proper hand and eye protection when searching for leaks. Use wood or cardboard instead of hands.
WARNING: Explosive fuel can cause fires and severe burns. Stop engine before filling fuel tank.
WARNING: Carbon monoxide can cause severe nausea, fainting or death. Do not operate engine in an enclosed or confined area.
WARNING: Hot parts can cause severe burns. Do not touch engine while operating or just after stopping.
WARNING: Acid from battery can cause fires and severe acid burns. Make sure to charge battery in well-ventilated area.
WARNING: Make sure to relieve hydraulic pressure before working on hydraulic system.
Choke
Fuel Shut-off
12
Operations
Throttle
Key
Advertisement
Table of Contents
