<
The address switch is used for setting both the
emulation and the printer address.
change the printer emulation, you must then
reset the printer device address.
part process described below to change the
printer emulation in a twinax environment.
In the first part of the process you set the
printer emulation.
emulate one of the printers (listed in Table 3-
1), follow this procedure:
Step 1.
Switch the printer off.
Step 2.
Disconnect the twinaxial T-cable from the
printer.
If, for example, you want to change the printer
to emulate a 5226, turn the address switch to
3.
Step 4.
Gently Press in the test button (identified in
Figure 3-4), and keep the test button depressed
through step 6.
cut top 2"
To have your printer
Address
Emulation
0
3812/5219/3816 (factory
1
5224 SCS printer
2
5225 SCS printer
3
5256 SCS printer
4
4234 SCS printer
5
3812/5219/3816
6
4245/6262 SCS printer
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
If you
Use the two
3-9