<
SETTING THE PRINTER EMULATION AND
DEVICE ADDRESS
You may need to change the printer emulation or
printer device address settings at a later
date.
device address does not require removing the
twinax interface card from the printer.
Procedures for changing the printer emulation
or device address are included in this section.
All other interface card configuration changes
require the removal of the card from the
printer and should be done only by your Xerox
service representative.
NOTE:
printer device address and printer emulation
can only be set through the FSL Function.
Refer to the Xerox Coax Command Reference for
instructions and a complete listing of coax
printers the 4219/MRP and 4215/MRP can emulate.
cut top 2"
Changing the printer emulation and
The coaxial default settings for the
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
3-7