Table of Contents
Advertisement
3.3.5
The below picture shows the height of the operable parts and display screen from the top and bot-
tom of the DC Wallbox' s enclosure (not accounting for piece on enclosure where the customer con-
duits connect to). It is the installer's responsibility to use this information to define the height at
which to install the DC Wallbox from the ground and to ensure compliance to local codes and regu-
lations (e.g. ADA requirements in the USA).
Installation instructions
4
About construction
4.1
The construction phase includes all work required to prepare the location and ensure it is ready for
the placement and connection of the Terra DC Wallbox charger. The construction phase can start
when:
•
The wall preparation work is done.
•
All necessary permits are granted.
•
The grid connection is available.
Instruction for a wall bearing
4.2
1. Drill and tap 4 holes and insert the plug for fixation in the wall at the indicated positions (re-
fer to technical drawing in the Appendix A par. 10.1). For safety purposes, the number of
recommended fixing screws is 4xST7.3x70. This is assuming the appropriate type of wall
plugs are used (depends on wall's characteristics, structure and type). It is the installer's
responsibility to choose an appropriate wall plug and to plan for a load of 820 N on each
plug.
2. When selecting the area along the wall for installation, ensure the required free spaces for
the Terra DC Wallbox cables are available (refer to section 3.4).
4.2.1
The Terra DC Wallbox can also be mounted on a pedestal. In order to achieve a safe installation,
the minimum set of requirements are included in Appendix C – Pedestal requirements). For the
ABB pedestal solution, contact your local ABB sales representative.
2 023 -06 -20
Considerations for where to position DC Wallbox vertically
Mounting on a pedestal
T ERR A D C WA LLB OX
2 0/39
Advertisement
Table of Contents
