Switch On The Machine - Xerox Phaser 3635MFP Quick Use Manual

Switch On the Machine

Once the machine has been assembled it must be configured. This is done using
the Product Enablement Key when the machine is switched on for the first time.
The Product Enablement Key is
delivered in a plastic tube inside
the box with the machine. The
procedure to configure the
machine is as follows:
1
Locate the tube containing the
Product Enablement Key.
Remove the plastic card and
carefully press out the key.
2
Connect the Power Cord to the
machine and a suitable power supply outlet.
3
Switch on the machine.
4
Install the Product Enablement Key into the Card Reader Slot at the back of the
machine.
5
The Language Default screen will be displayed. Select your chosen language
and then select Save.
6
The Installation Wizard screen will be displayed. Select Next.
7
The Product Enablement Settings screen will be displayed. Follow the
instructions on the screen.
NOTE:
When the Green LED light stops blinking and remains on continuously
(about 10 seconds), the configuration is successful.
8
Remove the Product Enablement Key and select Next on the display.
9
The Default Paper Size screen is displayed. Select either A4 or 8.5 x 11 inches
and select Next.
4
Product Enablement Key
Card Reader slot
Green LED
quick use guide