Xerox Phaser 3635MFP Quick Use Manual page 15

• On the Control Panel, press the Log In/Out button and then enter the
Administrator passcode [1111] and select Enter.
• Press the Machine Status button then select Tools > Connectivity and
Network Setup > Advanced > Network Setting > Network Setup > TCP/
IP Options > TCP/IP Settings.
• The allocated TCP/IP address is in the Name/Address field.
2
Confirm that an IP address has been allocated and that it is an appropriate IP
address for your network.
NOTE:
If the IP address starts with 169.xxx.xxx.xxx, the DHCP server has not
properly allocated an address or DHCP is not enabled on your network. Contact
your network administrator for assistance.
Network Setup Using a Static IP Address
Before you begin, obtain the following information from your network
administrator:
• IP Address
• Gateway Address
• Subnet Mask
• DNS Server Address
1
Press the Log In/Out button on the
Control Panel, enter the
Administrator's passcode [1111] and
select Enter.
2
Press the Machine Status button
then select Tools > Connectivity
and Network Setup > Advanced >
Network Setting > Network Setup >
TCP/IP Options.
3
Select HTTP and Enable. Select
Save.
4
Select TCP/IP Settings.
5
Select the Dynamic Addressing
button. By default, DHCP will be selected. Select Disabled to disable DHCP
and select Save.
6
Select Name/Address. Enter the Host Name, by selecting the Keyboard
symbol. Enter the IP Address by touching each box and entering the number
using the Numeric Keypad. Select Save.
7
Select Subnet and Gateway. Enter the Subnet Mask and IP Gateway. Select
Save.
8
If you do not wish to configure DNS settings proceed to the next step. If you
wish to configure DNS settings select the DNS Configuration button. Enter the
Domain Name and the Preferred DNS Server address. Select Save.
quick use guide 11