Advertisement
controller_A_1::> metrocluster operation show
Operation: heal-aggregates
State: successful
Start Time: 7/25/2016 18:45:55
End Time: 7/25/2016 18:45:56
Errors: -
5. Check the state of the aggregates by using the
controller_A_1::> storage aggregate show
Aggregate
RAID Status
--------- -------- --------- ----- ------- ------
---------------- ------------
...
aggr_b2
raid_dp, mirrored, normal...
6. Heal the root aggregates by using the
command.
mcc1A::> metrocluster heal -phase root-aggregates
[Job 137] Job succeeded: Heal Root Aggregates is successful
If the healing is vetoed, you have the option of reissuing the
with the -override-vetoes parameter. If you use this optional parameter, the system overrides any
soft vetoes that prevent the healing operation.
7. Verify that the heal operation is complete by using the
command on the destination cluster:
mcc1A::> metrocluster operation show
Operation: heal-root-aggregates
State: successful
Start Time: 7/29/2016 20:54:41
End Time: 7/29/2016 20:54:42
Errors: -
8. On the impaired controller module, disconnect the power supplies.
== Step 2: Remove the controller module
To access components inside the controller module, you must remove the controller module from the
Size Available Used% State
227.1GB
227.1GB
metrocluster heal -phase root-aggregates
storage aggregate show
#Vols
0% online
0 mcc1-a2
metrocluster heal
metrocluster operation show
command.
Nodes
command
279
Advertisement
