Viking S Series Service Notebook page 10

LP/PROPANE CONNECTION
Outdoor grills orificed for use with LP/Propane
gas come equipped with a high capacity
hose/regulator assembly for connection to a
standard 20 lb. LP/Propane cylinder equipped
with a 5LP-A coupler sleeve.
Connection: ½" NPT male with a 3/8" flare
adapter. Operating Pressure 11.0 W.C.P.
(Check owners installation instructions for full
detail as to local or national codes and/or
ordinances)
LEAK TESTING:
•
Do not smoke while leak testing.
extinguish all flames
•
Never leak test with an open flame.
•
Make a soap solution of one part liquid
detergent and one part water. You will
need a spray bottle, brush or towel to
apply the solution to the fittings. For
LP/Propane units, check with a full
cylinder.
•
Check that all control knobs are in the
"OFF" position.
•
Turn cylinder valve knob counter clock-
wise one turn to open.
•
Blowing bubbles in the soap solution
indicates that a leak is present.
•
Stop a leak by tightening the loose joint
or by replacing the faulty part. Do not
attempt to repair the cylinder valve if it
should become damaged.
•
If you are unable to stop a leak, shut off
the gas supply at the cylinder valve.
Remove the cylinder from the grill. Call
an authorized gas appliance service
technician or LP/Propane gas dealer.
•
After checking for leaks, push in and
turn any control knob to release the
pressure in the hose and manifold. Turn
off the control knob.
11