Viking T Series Service Manual

Viking T Series Service Manual

Hide thumbs Also See for T Series:

Advertisement

Service
Manual
This manual is to be used by qualified appliance technicians only.
Viking does not assume any responsibility for property damage
or personal injury for improper service procedures done by an
unqualified person.
Outdoor Gas Grills
(T-Series)
(VGBQ530-4RT model shown)
Preferred Service
This manual covers general and
specific information including, but not
limited to the following model:
VGBQ030-2T
VGBQ300-2RT (1)
VGIQ300-2RT (1)
VGBQ410-3RT
VGBQ412-2RT
VGIQ410-3RT (1)
VGIQ412-2RT (1)
VGBQ530-4RT
VGBQ532-3RT
VGIQ530-4RT (1)
VGIQ532-3RT (1)
SMO-0001
May 2009

Advertisement

Table of Contents
loading

Summary of Contents for Viking T Series

  • Page 1 Preferred Service Manual This manual is to be used by qualified appliance technicians only. Viking does not assume any responsibility for property damage or personal injury for improper service procedures done by an unqualified person. This manual covers general and specific information including, but not...
  • Page 2: Table Of Contents

    Electronic Ignition Switch ........18 Ignition Module ............19 Igniter ..............20 Infrared Igniter ............21 Rotisserie Igniter .............22 Parts Location–Burners ...........24 Side Burner .............25 Grill Burner .............26 Infrared Rotisserie Burner ........27 Rotisserie Motor .............29 Component Testing ..........30 Troubleshooting Guide ......... 30s © 2009 Viking Preferred Service...
  • Page 3: Important Information

    “DANGER”, “WARNING” or “CAUTION”. These words mean: CAUTION DANGER VIKING will not be responsible for any injury or property damage from improper service Immediate hazards which WILL result in severe procedures. If performing service on your personal injury or death.
  • Page 4: Warranty Information

    Viking Range Corporation service agency or representative. This warranty does not apply to commercial usage. Warrantor is not responsible for consequential or incidental damage whether arising out of breach of warranty, breach of contract, or otherwise.
  • Page 5: Warranty Service Information

    The return of the Owner Registration Card is not a condition of warranty coverage. You should, however, return the Owner Registration Card so that Viking Range Corporation can contact you should any question of safety arise which could affect you.
  • Page 6: General Information

    ( 7 4 2 ” . 2 c / 1 6 ( 1 0 . 9 c 4 ” ( 8 3 4 . 6 ” - 3 / . 2 c ( 8 3 © 2009 Viking Preferred Service...
  • Page 7 - 5 / . 9 c ( 4 2 8 ” . 4 c - 3 / ( 1 3 ” 5 . 1 4 ” - 3 / . 2 c ( 8 3 © 2009 Viking Preferred Service...
  • Page 8: Warnings

    This outdoor gas grill is not intended to be straightened out. Shake out any debris through installed in or on recreational vehicles and/or the air shutter. boats. © 2009 Viking Preferred Service...
  • Page 9 DO NOT 2. Any LP cylinder not connected for use shall USE AN OPEN FLAME TO CHECK FOR LEAKS. not be stored in the vicinity of this or any other appliance. © 2009 Viking Preferred Service...
  • Page 10: Model - Serial Number Matrix

    V G I Q 5 3 2 3 R T 1 L S S V=Professional Series Stainless Steel L.P. Gas T-Series Infrared Grill Rotisserie 53” 3 Grill Burners 2 Side Burners Serial Numbers 02 10 09 C00006566 Month Serial Number Year of Manufacture © 2009 Viking Preferred Service...
  • Page 11: Operation

    This allows optimum performance of the hood. flash tubes. the outdoor hood may be compromised. If you have just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. © 2009 Viking Preferred Service...
  • Page 12 “HIGH” and “LOW.” The location of the infrared burner makes it more susceptible to strong wind conditions—more so than the protected grill burners. For this reason you should be cleaned after each use.) © 2009 Viking Preferred Service...
  • Page 13: Smoker Burner And Smoker Box

    © 2009 Viking Preferred Service...
  • Page 14: Service Diagnostics And Procedures

    Switch Switch VGIQ300-2RT VGBQ410-3RT Rotisserie Grill Grill Grill/Smoker Tru Sear Grill/Smoker Rotisserie Grill Infrared Ignition Ignition Switch Switch VGBQ412-2RT VGIQ410-3RT Side Rotisserie Grill Grill/Smoker Rotisserie Grill Grill/Smoker Rear Side Grill Tru Sear Grill Front Infrared © 2009 Viking Preferred Service...
  • Page 15 Switch VGBQ532-3RT VGIQ530-4RT Side Grill Grill Grill Tru Sear Grill Grill Grill Front Infrared Side Rotisserie Grill/Smoker Rotisserie Rotisserie Grill/Smoker Rear Ignition Switch VGIQ532-3RT Side Tru Sear Grill Grill Front Infrared Side Rotisserie Grill/Smoker Rear © 2009 Viking Preferred Service...
  • Page 16: Parts Location-Control Panel

    Parts Location–Control Access Panel Removed (VGIQ530-4RT model shown) Ignition Infrared Grill Grill Grill Grill Rotisserie Module Burner Valve Igniter Igniter Valve Valve Valve Infrared Rotisserie Grill Grill Grill Ignition Grill Igniter Valve Valve Valve Igniter Module Igniter © 2009 Viking Preferred Service...
  • Page 17: Parts Location-Rear View

    Service Diagnostics and Procedures Parts Location–Rear Access Panel Removed (VGIQ530-4RT model shown) Right Side Right Side Left Side Left Side Rotisserie Rotisserie Rotisserie Rotisserie Igniter Burner Burner Igniter © 2009 Viking Preferred Service...
  • Page 18: Control Pane Components Access

    3. Reverse procedure to reassemble. 4. Lower the control panel. Verify the switch reads open in the extended position and 0 in the pressed position. Ω Note: Make sure to replace with a momentary switch. Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 19: Ignition Module

    Verify the 9 VDC battery is proper. If voltage is proper and no spark is present at the igniter, check the switch, igniter, and wiring. If all check good, replace the module. Ignition module Screws Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 20: Igniter

    If power is Disconnect wiring and remove control panel. supplied to the igniter and no spark, replace the igniter 2. Locate igniter(s). Igniter Test Points Remove screw securing igniter. Screw Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 21: Infrared Igniter

    If power is supplied to the igniter and no spark, replace the igniter. 4. Remove two screws securing igniter cover, remove igniter cover. Screws Test Points Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 22: Rotisserie Igniter

    2. Locate rotisserie igniter cover(s). Remove three screws securing rack support and two screws securing igniter cover. Screw Screws Igniter Cover Screws 6. Remove igniter. Rack Support 7. Reverse procedure to reassemble. Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 23 If the igniter fails to spark, first do a resistance check on the igniter. If the igniter shows 0 , check Ω ignition module, wiring, and battery. If power is supplied to the igniter and no spark, replace the igniter. Test Points © 2009 Viking Preferred Service...
  • Page 24: Parts Location-Burners

    Left Side Right Side Right Side Right Side Rotisserie Sear Burner Dual Grill Single Grill Rotisserie Rotisserie Igniter and Burner Burner Igniter and Burner Left Side Right Side Thermocouple Thermocouple Rotisserie Dual Grill Burner Burner © 2009 Viking Preferred Service...
  • Page 25: Side Burner

    3. Lift burner and separate air shutter from orifice. and the supply is available. If supply is proper and still no flow verify gas valve and orifice. If orifice or air shutter is not plugged and still not flowing, replace the gas valve. © 2009 Viking Preferred Service...
  • Page 26: Grill Burner

    1. Open canopy and remove grill grates. 5. Remove nut from rear of each single burner. 2. Remove flavor generator plates. 6. Remove two nuts from front of dual burner. 3. Remove nuts on drip guards. © 2009 Viking Preferred Service...
  • Page 27: Infrared Rotisserie Burner

    If orifice or air shutter is not plugged and connections are proper. Replace or repair as and still not flowing, replace the gas valve. needed. To access the Rotisserie Burner: 1. Open lid and remove upper rack. Upper Rack © 2009 Viking Preferred Service...
  • Page 28 Igniter Cover Screws 3. Remove screws and rear access panel. Remove screws securing burner(s). Rear View Screws Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 29: Rotisserie Motor

    Ω open in the off position. Ensure the cord is securely attached. If the switch and cord are proper and the motor still does not turn, replace the motor. Note: VGIQ530-4RT model shown © 2009 Viking Preferred Service...
  • Page 30: Component Testing

    Infrared screen Verify no black spots on screen. Grill rotisserie fails to Electrical cord Verify secure connection. operate Circuit breaker Verify breaker is not tripped or fuse is blown. Power supply Verify power is available. © 2009 Viking Preferred Service...

Table of Contents