Table of Contents
Advertisement
3.1 Terminal Block Connector Pinout
To install the 3-pin Terminal Block Connector on the Wall-mount Managed
Switch, simply follow the following steps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into
V-, and grounding wire into Ground.
Step 2: Tighten the wire-clamp screws for preventing the wires from
loosening and plug them into the Wall-mount Managed switch.
1. The wire gauge should be in the range from 12 to 24 AWG.
2. The device must be grounded.
6
Ground
V
-
V+
Advertisement
Table of Contents
