Table of Contents
Advertisement
Configuration of the IP Address
3. At the "#" prompt, enter the following command and press <Enter> as
shown in following.
WGS-5225-8P2SV# configure terminal
WGS-5225-8P2SV (config)# interface vlan 1
WGS-5225-8P2SV (config-if-vlan)# ip address 192.168.1.100
255.255.255.0
The previous command would apply the following settings for the Wall-mount
Managed Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
4. Repeat step 1 to check if the IP address has changed.
6.2 Storing the Current Switch Configuration
At the "#" prompt, enter the following command and press <Enter>.
# copy running-config startup-config
Figure 6-3: Saving Current Configuration Command Screen
If the IP is successfully configured, the Wall-mount Managed Switch will apply
the new IP address setting immediately. You can access the Web interface of
the Wall-mount Managed Switch through the new IP address.
17
Advertisement
Table of Contents
