Table of Contents
Advertisement
4. Have a second person hold the Handrails (66) near the
Uprights (69) as shown. Connect the Upright Wire
Harness (98) to the wires extendingfrom the Console
Base (81). Insert the connectors and the Upright Wire
Harness into the hole in the right Upright.
Set the Handrails (66) on the Uprights (69), being careful
not to pinch the Upright Wire Harness (98).
66
5. Insert two Handrail Bolts (78) with Handrail Spacers
(77) intothe right Upright (69) and the right Handrail
(66). Be careful not to pinch the Wires. Make sure
that the Handrail Spacers are flush against the right
Uprightwith the thick sides facing the center of the
treadmill, as shown in the inset drawing. Next, lift the
right Handrail (66) slightlyand align the Boltswith the
holes in the Handrail. Thread the Bolts intothe
Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
Thick
Side
6. Make sure that all parts are properly tightened before you use the treadmill. Note: If there is a thin sheet
of clear plastic on the hood decal, remove it. Keep the included allen wrench in a secure place. The allen
wrench is used to adjustthe walking belt (see page 27). To protectthe floor or carpet from damage, place a
mat under the treadmill.
Advertisement
Table of Contents
