Table of Contents
Advertisement
PROBLEM:
The walking
belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressorthat meets all of the specificationsdescribed on page 8.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both
rear roller adjustment bolts counterclockwise, 1/4 of a
turn. When the walking belt is propedy tightened, you
should be able to lift each side of the walking belt 3 to
4 inches offthe walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in-
sert the key, and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
Rear Roller Adjustment Bolts
c. If the walking belt stillslows when walked on, please call our Customer Service Department, toll-
free.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, remove the key and UN-
PLUG THE POWER CORD. If the walking belt has
shifted to the left, use the allen wrench to turn the left
rear roller boltclockwise1/2 of a turn; if the walking belt
has shifted to the right, turnthe left rear rollerboltcoun-
terclockwise1/2 of a turn, Be careful not to overtightenthe
walking belt. Plug in the powercord, insertthe key, and
run the treadmillfor a few minutes. Repeat untilthe walk-
ing belt is centered,
b4
If the walking belt slipswhen walked on, first remove the
key and UNPLUG THE POWER CORD. Using the allen
wrench, turn both rear roller bolts clockwise, 1/4 of a turn.
When the walking belt is correctly tightened, you should
be able to lift each side of the walking belt 3 to 4 inches off
the walking platform. Be careful to keep the walking belt
centered. Plug in the power cord, insert the key, and care-
fully walk on the treadmill for a few minutes. Repeat until
the walking belt is properly tightened.
PROBLEM:
The incline of the treadmill
does not change correctly
or does not change when iFIT.com
CD's and videos are played
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-
move the key. After a few seconds, re-insertthe key. The treadmillwill automaticallyrise to the
maximum inclinelevel and then return to the minimum level. This will recalibratethe incline.
27
Advertisement
Table of Contents
