Table of Contents
Advertisement
System Status LED
Table 2: System Status LED
Color/State
No lights
Green- blinking
1
Green- solid
Green/Amber - alternating
Amber- solid
Red- solid
1. Blinking: one second on, one second off, 2 seconds cycle.
2. Alternating: one second each color, 2 second cycle.
Reset Button
The reset button can be used to reset the access point to factory default settings.
There are two ways to reset the access point to factory default settings:
To reset the AP during normal operation, press and hold down the reset button using a small,
n
narrow object such as a paper clip for more than 10 seconds during normal operation.
To reset the AP while powering up, follow these steps:
n
1. Press and hold down the reset button using a small, narrow object such as a paper clip while the
access point is not powered on.
2. Connect the power supply to the access point while the reset button is being held down.
3. Release the reset button on the access point after 15 seconds.
Ethernet Port
The HPE Networking Instant On Access Point AP27 is equipped with one 100/1000 Base-T, auto-sensing
MDI/MDX Ethernet port (E0). The E0 port supports IEEE 802.3at Power over Ethernet (PoE), allowing the
AP to draw power from compliant PoE power sources.
Grounding Point
Always remember to protect the access point by installing grounding lines. The ground connection must
be complete before connecting power to the access point enclosure.
HPE Networking Instant On Access Point AP27 | Installation Guide
2
Meaning
The AP has no power.
The AP is booting, not ready.
The AP is ready, fully functional, no network
restrictions.
The AP is ready for configurations.
The AP has detected a problem.
The AP has an issue - immediate action
required.
5
Advertisement
Table of Contents
