Table of Contents
Advertisement
Installation
All Hewlett Packard Enterprise access points should be professionally installed by a professional installer. The
installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes.
Failure to properly install this product may result in physical injury and/or damage to property.
Tous les points d'accès Hewlett Packard Enterprise doivent impérativement être installés par un professionnel
agréé. Ce dernier doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux
codes électriques nationaux en vigueur. Le fait de ne pas installer correctement ce produit peut entraîner des
blessures corporelles et / ou des dommages matériels.
Use of accessories, transducers and cables other than those specified or provided by the manufacturer of this
equipment could result in increased electromagnetic emissions or decreased electromagnetic immunity of this
equipment and result in improper operation.
Before You Begin
Refer to the sections below before beginning the installation process.
FCC Statement: Improper termination of access points installed in the United States configured to non-US model
controllers will be in violation of the FCC grant of equipment authorization. Any such willful or intentional violation
may result in a requirement by the FCC for immediate termination of operation and may be subject to forfeiture
(47 CFR 1.80).
Pre-Installation Checklist
Before installing the access point, be sure that you have the following (not included with the AP):
One or two Cat5E or better UTP cables with network access
n
Some optional items:
A compatible PoE injector with power cord
n
Refer to the HPE Networking Instant On Access Point AP27 data sheet for compatible items, quantities
needed, etc.
HPE Networking Instant On Access Point AP27 | Installation Guide
Chapter 3
Installation
6
Advertisement
Table of Contents
