Access Point Installation - HPE Instant On AP27 Installation Manual

Access Point Installation

Mounting the AP to a Solid Surface
The HPE Networking Instant On Access Point AP27 ships with a mount bracket to mount the AP to a
solid surface, such as a wall.
To install the HPE Networking Instant On Access Point AP27 to a wall, follow these steps:
1. Use the mount bracket as the template to mark the four mounting points on the wall, and use a
drill to make four holes on the four markings.
2. Insert an anchor bolt (not included in the package) into each drilled hole, then place the mount
bracket over the anchor bolts, and press the mount bracket against the wall.
3. Place the washers and a nut onto each bolt's threaded end, and tighten the nut until the mount
bracket is firmly attached to the wall.
Figure 3 Attaching Mount Bracket to Wall
4. Slide the holder of the AP into the opening of the mount bracket, and use the two M6 x 20 screws
included in the package to secure the AP to the mount bracket.
HPE Networking Instant On Access Point AP27 | Installation Guide 8