Section 7: Regulatory Information - Elo TouchSystems I 3 Series User Manual

Section 7: Regulatory Information

Electrical Safety Information
Compliance is required with respect to the voltage, frequency, and current requirements indicated
on the manufacturer's label. Connection to a different power source than those specified herein will
likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are
not followed.
There are no operator serviceable parts inside this equipment. There are hazardous voltages
generated by this equipment which constitute a safety hazard. Service shall be provided only by a
qualified service technician.
Contact a qualified electrician or the manufacturer if there are questions about the installation prior
to connecting the equipment to mains power.
Emissions and Immunity Information
Notice to Users in the United States for FCC compliance:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user 's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
User Manual: I-Series 3 with Intel®
UM600733 Rev A, page 30 of 40