Section 6: Safety & Maintenance - Elo TouchSystems I 3 Series User Manual

Section 6: Safety & Maintenance
Safety
To avoid the risk of electric shock, follow all safety notices and do not disassemble the touch computer. They are not user serviceable.

Do not block or insert anything inside the ventilation slots.

The Elo touch computer system is equipped with an AC/DC power adaptor. Do not use a damaged AC/DC power adaptor. Use only the

AC/DC power adaptor supplied by Elo for touch computer system. Use of an unauthorized AC/DC power adaptor may void your warranty.
Ensure that the system is maintained and runs within the specified environmental conditions listed below.

The equipment power supply cord shall be connected to a socket-outlet with earthing connection.

Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions

Be sure to disconnect the power source before disassembling the equipment. The enclosure must be completely assembled while restoring the

power input. Wait one-half hour after switching off before handling parts.
Environmental conditions for operating and storage
Temperature:
Operating
Storage
Humidity (non-condensing):
Operating
Storage
Altitude:
Operating
Storage
Power ratings
24 volts, 7.5 Amps max
Ingress Protection
IP54 - Under the following conditions:
Keep all connector and peripheral covers tightly sealed. Power brick doesn't comply with IP54 rating.
IP54 compliant in landscape orientation only, and not when mounted face-up or face-down.
Note: The thermal report pass airflow 0.5m/s + CPU Minimum assured power condition. For non-OS SKUs, recommend installing the Elo optimize TDP
tool for better performance.
0°C to 35°C
-30°C to 60°C
20% to 80%
5% to 95%
0 to 3,048 m
0 to 12,192 m
User Manual: I-Series 3 with Intel®
UM600733 Rev A, page 27 of 40