Table of Contents
Advertisement
●
The display shows Emergency on the current zone and channel. A tone sounds and the LED
blinks red momentarily.
●
A tone sounds to indicate that the selected channel does not support emergency and rejects to
launch emergency mode.
2. The microphone remains active for the hot mic time specified in the radio's codeplug programming.
3. To exit Emergency Call, press and hold the preprogrammed Emergency button.
7.10.9
Sending an Emergency Alarm with Emergency Call
When and where to use:
This feature gives your radio priority access on a channel for conventional system, and to a talkgroup for
trunking system.
Procedure:
1. Press the preprogrammed Emergency button.
If successful, the display shows Emergency on the current zone and channel. You hear a short,
medium-pitched tone and the LED blinks red momentarily.
The radio exits Emergency Alarm and enters the Emergency Call state when one of the following
scenarios occur:
●
You receive the dispatcher acknowledgment. The display shows Ack received.
●
You receive no acknowledgment. The display shows No acknowledge.
●
You press the PTT button while in the Emergency Alarm mode.
If unsuccessful, you hear the radio sounds a short low-pitched tone to indicate the selected channel
does not support emergency and rejects to launch emergency mode.
2. Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from your mouth.
3. Press and hold the PTT button. Speak clearly into the microphone.
4. Release the PTT button to end the transmission and wait for a response from the dispatcher.
5. To exit Emergency Call, press and hold the preprogrammed Emergency button for about a second.
Turning off the radio also cancels the emergency state.
7.10.10
Sending An Emergency Alarm and Call with Hot Mic
This feature allows you to send an Emergency Alarm and Call with hot mic to a group of radios.
When and where to use: Your radio must be programmed for this type of operation.
When indirect PTT such as Hot Mic is activated, the audio transmission can be configured in CPS to route
the audio to the radio internal microphone, wired RSM microphone, or Bluetooth wireless microphone.
Follow the procedure to send Emergency Alarms and Call with hot mic on your radio.
Procedure:
1. Press the preprogrammed Emergency button.
MN001824A01-AT
Chapter 7: Advanced Features
73
Advertisement
Table of Contents
