Sending An Emergency Call (Trunking Only); Sending An Emergency Alarm With Emergency Call - Motorola APX 400Li 1 User Manual

Sending an Emergency Call (Trunking Only)

This feature gives your radio priority access to a
talkgroup.
1 Press the preprogrammed Emergency button.
One of the following scenarios will occur:
• The display shows Emergency on the current
zone and channel. You hear a short medium-
pitched tone and the LED blinks red
momentarily.
• You hear the radio sounds a short low-pitched
tone to indicate the selected channel does not
support emergency and rejects to launch
emergency mode.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
3 Press and hold the PTT button. Speak clearly into
the microphone.
4 Release the PTT button to end the transmission
and wait for a response from the dispatcher.
50
English
All manuals and user guides at all-guides.com

Sending an Emergency Alarm with Emergency Call

5 To exit Emergency Call, press and hold the
preprogrammed Emergency button for about a
second.
This feature gives your radio priority access on a
channel for conventional system, and to a talkgroup
for trunking system.
1 Press the preprogrammed Emergency button.
If successful, the display shows Emergency on the
current zone and channel. You hear a short,
medium-pitched tone and the LED blinks red
momentarily.
The radio exits Emergency Alarm and enters the
Emergency Call state when one of the following
scenarios occur:
• You receive the dispatcher's acknowledgment.
The display shows Ack received.
• You receive no acknowledgement. The display
shows No acknowledge.
• You press the PTT button while in the
Emergency Alarm mode.