Table of Contents
Advertisement
2.5.
Set MDC-211-ZT as Modbus Slave
One of the MDC-211-ZT ZigBee/RS-232/RS-485 ports can be set as Modbus Master or
Modbus Slave (Ethernet port can only be used as Modbus Slave). This section describes how
to set the communication interface as Modbus Slave.
Set communication interface to Modbus Slave
Click "Module Setting" → "Modbus RTU/TCP" → click "Modify" → Select the one of
the " ZigBee / RS-232 / RS-485" and set "Modbus Status" as Modbus Slave. Finally, set the
station number (1~255) of MDC-211-ZT as the Modbus Slave.
1
2
4
3
Figure 2.11 Modbus RTU/TCP Protocol parameter setting page
ICP DAS, MDC-211-ZT user manual , v1.0
Page 19
Copyright © 2018 by ICP DAS. All rights are reserved.
Advertisement
Table of Contents
