Set Port Information - ICP DAS USA MDC-211-ZT User Manual

2.3.

Set Port Information

MDC-211-ZT provides one port ZigBee, one port Ethernet, one port RS-232 and one
port RS-485 communication interface, this section introduces the configuration procedure
for these communication interface.
 ZigBee Port Setting
Click "Module Setting" → "ZigBee", to read the current ZigBee setting parameters, if
user want to adjust the ZigBee settings, click the "Modify" button to switch to the
configuration page, as shown in Figure 2.6.
Figure 2.6 Steps to switch to the ZigBee configuration page
For the description of the ZigBee settings, please refer to section "4.1.1 ZigBee
Communication Interface". After modifying the setting parameters, please remember to click
"Save" button to save the changes, or click the "Cancel" button to discard the configuration
and return to the previous page.
NOTE - The new ZigBee settings will take effect immediately after configuration without
restarting the power of the MDC-211-ZT.
1
2
3
ICP DAS, MDC-211-ZT user manual , v1.0
Copyright © 2018 by ICP DAS. All rights are reserved.
Page 14
4