Getting Started With Mdc-211-Zt - ICP DAS USA MDC-211-ZT User Manual

2. Getting Started With MDC-211-ZT

This chapter mainly describes the operation process of the MDC-211-ZT, such as, how to use
the MDC-211-ZT Web interface via browser, and set up the Modbus Master and Modbus
Slave function for the Modbus data concentrator.
 MDC-211-ZT Setting Flowchart
•Hardware wiring
•Set the MDC-211-ZT and PC to the same local area network. (The default IP address of
Preparation
MDC-211-ZT is 192.168.255.1)
•Launch the browser and enter the IP address of MDC-211-ZT
•login MDC-211-ZT (Both the default account and password are "Admin")
Web Login
•Change a new account/password for higher security
•Configure communication port settings according to the user needs.
Port
Settings
•Set the communication interface to Modbus Master according to the actual requirements,
and adjust the related setting parameter values.
Modbus
•Add Modbus RTU commands to specific communication port for Modbus data
acquisition.
Master
•Set the communication interface to Modbus Slave according to the actual requirements,
Modbus
and set its Modbus Slave ID.
Slave
•Export: Export the MDC-211-ZT setting parameters to a. csv file for backup.
System
•Import: Import the configurations into the MDC-211-ZT via a .csv file.
Backup
•Check the polling state of each Modbus commands.
Check •Get the address mapping table between the remote Modbus RTU devices and Internal
Polling State
Registers of MDC-211-ZT.
ICP DAS, MDC-211-ZT user manual , v1.0
Copyright © 2018 by ICP DAS. All rights are reserved.
Page 9