Removing The Engine Guard (All Special Models); Installing The Engine Guard (All Special Models) - KTM 300 EXC ERZBERGRODEO 2023 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.45
12.46
96
S04882-10
E01224-10

Removing the engine guard (All special models)

H01638-10

Installing the engine guard (All special models)

H01638-10
–
4
Fill bleeding syringe with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder protection cap,
release the bleeder screw
–
Now press the fluid into the system until it emerges from the
6
hole of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Tighten the bleeder screw.
Mount protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
1
Remove screws and engine guard.
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
p. 168)
5
and mount bleeding syringe
4 mm (0.16 in)
1
.
M6 10 Nm (7.4 lbf ft)
4
.