Removing The Engine Guard (All Six Days Models); Installing The Engine Guard (All Six Days Models) - KTM 250 EXC Six Days TPI 2019 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.46
12.47
98
E01224-10

Removing the engine guard (All Six Days models)

H01638-10

Installing the engine guard (All Six Days models)

H01638-10
–
Now press the fluid into the system until it emerges from the
6
hole of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Tighten the bleeder screw.
Mount protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
1
Remove screws and engine guard.
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
4 mm (0.16 in)
1
.
M6 10 Nm (7.4 lbf ft)