KTM 350 EXC-F 2024 Owner's Manual page 107

Main work
–
Cover the painted parts.
–
Remove screw cap
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir;
extract some if necessary.
Info
Make sure that you do not press the brake caliper
R06286-10
against the spokes when pushing back the brake piston.
–
Remove cotter pin
linings.
–
Clean the brake caliper and the brake caliper bracket.
R06322-10
–
Check that spring plate
sliding plate
rectly.
R06323-10
–
Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
E00353-01
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
R06288-11
Finishing work
–
Install the frame protector. (
1
with the membrane and the O-ring.
2 3
, pull out pin , and remove the brake
4
in the brake caliper and brake pad
5
in the brake caliper bracket are seated cor-
A .
p. 158)
1
with the membrane and O-
p. 62)
BRAKE SYSTEM 13
105