List Of Names - THORLABS ULN15TK User Manual

Ultra-Low-Noise Laser System
4.2.3

List of Names

Corresponding to the 'read_string' command
Name
oem
module_sn
main_board_sn
laser_sn
List of Responses
Value
000: OK
100: Unknown command
101: Syntax error
102: Invalid parameter
103: Unknown Tag
104: Not Writeable
105: Unknown Response
106: Device Error
111: Response Too Large
Rev. A, August 17, 2022
OEM string
Module serial number
Main board serial number
Laser serial number
Command executed successfully
Executed command is unknown
Incorrect number of parameters or the formatting of the parameters is
incorrect.
One of the specified parameters is out of range of allowable values.
A command that takes a tag as a parameter was given a string that it could
not find in the system.
An attempt was made to write a tag value that cannot be modified either
because it is read only or the user does not have the appropriate permission.
This is an internal failure of the device. This should generally only be
returned if there is a software defect.
An error was encountered in the hardware while attempting to execute the
command. NOTE: When this failure happens, the unit may be in an
undefined state. For example, tag values that are written by a command may
not reflect actual hardware settings when the tag is read.
Occurs when a command has a variable length response, and that response
is too large to be sent back to the host.
Chapter 4: Software Communications
Descriptions
Descriptions
Page 9