List Of States - THORLABS ULN15TK User Manual

Ultra-Low-Noise Laser System
List of Commands
See corresponding subsections for details.
Command
laser [state]
write_param [tag] [value]
read_param [tag]
save_param [tag]
read_string [name]
savecfg
get_clock
update
reset
firmware_version
4.2.1

List of States

Corresponding to the 'laser' command
Command
on
off
Rev. A, August 17, 2022
Set the user requested state of the laser.
Write a parameter to the device
Read a parameter from the device
Immediately write a parameter to EEPROM.
Read a string value from the device
Save all parameters on the main and optics boards to non-volatile
memory.
Gets the currently set time and date.
Places the system into a mode where it can accept firmware updates from
the PC.
Reset the system. Note that this will drop the USB connection.
Read the current firmware version number.
Set the requested state to on.
When system failures are cleared and interlock indicates OK, the laser till turn on.
When system errors occur or when interlock is lost, the laser is tuned off.
Laser is turned off.
Chapter 4: Software Communications
Descriptions
Descriptions
Page 7