Table of Contents
Advertisement
AXIS C15 Series
Specifications
SD card slot
NOTICE
NO
NO
TICE
TICE
• Risk of damage to SD card. Don't use sharp tools, metal objects, or excessive force when inserting or removing the SD card.
Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Unmount the SD card from the device's web interface before removing it.
Don't remove the SD card while the product is running.
For SD card recommendations, see axis.com.
SD, SDHC, and SDXC Logos are trademarks of SD-3C LLC. SD, SDHC and SDXC are trademarks or registered
trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Calibrating the speaker test. Press and release the control button and a test tone is played.
•
Resetting the product to factory default settings. See Reset to factory default settings on page 41.
Microphone disable switch
For location of the microphone disable switch, see Product overview on page 44.
The microphone disable switch is used to mechanically turn the microphone ON or OFF. The factory default setting for this switch
is ON.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO
NOTICE
NO
TICE
TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see the Installation Guide at www.axis.com.
Audio connector
•
Audio in – 3.5 mm input for a stereo microphone, or a line-in stereo signal.
Audio input
1 Tip
Unbalanced microphone (with or without electret
power) or line
2 Ring
Electret power if selected
45
3 Sleeve
Ground
Advertisement
Table of Contents
